B&K Pro10 Spezifikationen

Page 1 Table of contents Safety precautions page 3 Introduction page 4 Front panel view

Page 10 PHONO GROUND - For connection of your ground wire for phono use. POWER CONNECTION - For connection of the included power supply. ** Cau

Page 11 selector switch. 3. Trim the leads of the capacitors (one required per channel) to approximately _ inch. 4. Insert the leads into the C

Page 12 NOTE: You may not be able to attain the proper value resistor to fit you application, use the closest standard value you can find. Refer t

Page 13 Figure 1 Block Diagram

Page 14

Page 15 Making the connection The diagram below shows a typical connection between the preamplifier and a B&K amplifier using the unbalanced R

Page 16

Page 17 PRO10 Specifications Moving Coil Sensitivity (at 1kHz) .09 mV Moving Coil Overload (at 1kHz) 17 mV Moving Coil Load Re

Page 18 Limited Warranty B&K Components Ltd., referred to herein as B&K, warrants your B&K equipment against all defects in material a

Page 2 Unbalanced Preouts page 9 Tape Monitor Loop page 9 Line Level Inputs page 9 Phono Inputs

Page 3 SAFETY PRECAUTIONS PLEASE READ BEFORE INSTALLING • Turn preamplifier ‘off’ when plugging in or unplugging input and speaker cables

Page 4 Introduction Thank you for selecting B&K Components, Ltd.’s PRO10 preamplifier. The PRO10 is designed for the discriminating audiophil

Page 5 Front panel view 1. Record selector knob 2. Source selector knob 3. Tape monitor button 4. Direct bypass button 5. Power switch (mut

Page 6 Front panel description RECORD - Controls which one of the six input pairs is routed directly to the record output connectors (REC OUT).

Page 7 BALANCE - The balance control is used to adjust the relative volume of the left and right channels. This affects the PRE AMP OUT connectio

Page 8 Back panel view 1. Balanced pre-outputs 2. Unbalanced pre-outputs (RCA) 3. Tape monitor loop 4. Line level inputs 5. Phono inp

Page 9 Back panel description BALANCED PREOUTS - For use with balanced output cables when your amplifier has balanced inputs. The balanced outp