B&K 2250 Light Bedienungsanleitung PDF herunterladen (Seite 100)

Hand-held Analyzer Types 2250 and 2270 – User Manual

Table 8.2 Content of Notification

Note: Some of the information listed above may not be available, depending on the conditions

when the notification was sent, for example, no measurement values will be available

immediately after a power on.

8.4.2 Text/SMS Notifications

Notifications via SMS (text message) can be used if you have connected a

GSM/GPRS/EDGE/HSPA modem to the analyzer (see section 8.2.2) and set Modem to

Disabled (a text message cannot be sent if the modem is set to GPRS/EDGE/HSPA Dialup).

In addition to sending notifications initiated by alarms, you can send an ‘Info’ text to the

analyzer and ask for an SMS notification, after which you will get a notification within 30

seconds.

You need to setup a Phone Number in Preferences > Notifications > SMS and set Active to Yes

for the SMS. You can also add a Name for the number for easier identification.

You can setup two individual SMS phone numbers for sending the SMS notification to two

recipients.

Set Notification to SMS and a notification will be sent by SMS to the active phone numbers,

when any of the alarm conditions are met, or if the analyzer receives an ‘Info’ SMS.

Information Type Content

Reason for notification ‘Test’, ‘Alarm’ or ‘Status’ followed by a short description

Time of notification Date and Time

Instrument ID Serial No. and Location

Status of current Disk Free memory / Total memory

Status of Internal Battery Full, High, Low, Critical, Charging or Unknown

Trigger Input Voltage (if available) The voltage

Measurement Status (if available) Running, Paused or Stopped

No. of Signal Recordings (if

available)

The number of signal recordings made since start of

measurement

Latest CIC Result (if available) Passed, Background noise too high, Ratio outside tolerances,

Ratio deviates from Ref., Undefined Ref., or Undefined. For

2-channel measurements: One CIC result per channel

Current value of LAF (if available) The value. For 2-channel measurements: One CIC result per

channel

Report Threshold Level The value

Report Level LAeq The value

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 331 332

Keine Kommentare

B&K 2250 Light Bedienungsanleitung Seite 100